MB102 830 Points Solderless Prototype PCB Breadboard
1. 100% brand new and high quality
2. Practical and useful
3. Solderless breadboard with 840 points
4. Completely reusable and have a self-adhesive back
5. Easy component placement
MG995 Servo Motor (360 Degree)
1. Model: MG995
2. Weight: 55 gm
3. Operating voltage: 4.8V~ 7.2V
4. Servo Plug: JR
5. Stall torque @4.8V : 9.4kg-cm
6. Stall torque @6.6V : 11kg-cm
Mini BreadBoard 170 Points SYB-170 – White
1. Tie-points: 170 (10×17)
2. Size: 48 x 35 x 10 mm(LxWxH).
3. Use: experimental, testing, robot
4. Matching jumper, diameter 0.8mm
5. Phosphor bronze nickel plated spring clips
6. Accepts a variety of wire sizes (29-20 the AWG)
Mini Water Pump Motor 3-6v DC
1.Operating Voltage : 2.5 ~ 6V
2.Operating Current : 130 ~ 220mA
3.Flow Rate : 80 ~ 120 L/H
4.Maximum Lift : 40 ~ 110 mm
5.Outlet Outside Diameter: 7.5 mm
6.Outlet Inside Diameter: 5 mm
Motor Driver – L293D
1. The driver two holes of 3 mm dia.
2. Male burg-stick connectors for supply, ground and input connection.
3. Screw terminal connectors for easy motor connection.
4. High noise immunity inputs.
5. Operating Voltage(VDC): 4.5 to 12
6. Peak Current (A): 600 mA
7. No. of Channels: 1
Motor Driver – L298N
1. Current Sense for each motor.
2. Heatsink for better performance.
3. Power-On LED indicator.
4. Double H bridge Drive Chip: L298N.
5. Operating Voltage(VDC): 5~35
6. Peak Current (A): 2
7. Continuous Current (A): 0-36mA
8. No. of Channels: 2
9. Over-Current Protection (A): Yes
10. Thermal Protection: Yes
Motor/Stepper/Servo Shield v2 For Arduino
1. This serrvo motor shield compatible with arduino is used for vehicles & Remote Control Toys.
2. It’s an I2C-controlled PWM driver with a built-in clock.
3. The 12 bit servo motor also features protection against reverse polarity on the terminal block input.
MP3 Module With Power Amplifier
1. Support MP3 format, playing power on automatically.
2. When mp3 is played the red LED flashes.
3. Support U disk (test 32G), TF Card (test 16G) play mode; power on default.
4. Buttons can be adjusted up and down to control songs, volume up and down, pause or play, mode switching.
5. Press menu button enter the single / all song play mode.
MQ135 Gas Sensor – Air Quality
1. Sensitivity to Ammonia, Sulphide and Benzene steam
2. Sensitive for benzene, alcohol, smoke
3. Fast response and recovery
4. Adjustable sensitivity
5. Signal output indicator
6. Output voltage boosts along with the concentration of the measured gases increases.
MQ2 Gas Sensor – Methane, Butane, LPG, Smoke
1. Operating Voltage:+5V
2. Preheat Duration:20 s
3. Analog Output Voltage:0 to 5 V
4. Dimension:36x20x21 mm
MQ3 Gas Sensor – Alcohol, Ethanol, Smoke
1. Power requirements: 5 VDC @ ~165 mA (heater on) / ~60 mA (heater off).
2. Current Consumption: 150mA.
3. DO output: 0.1 and 5V.
4. AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V
5. Detecting Concentration: 0.05-10mg/L Alcohol.
MQ4 Gas Sensor – Methane, CNG Gas
1. Detecting range: 300~10000ppm
2. Signal output indicator.
3. Dual Signal output (analog output and TTL output).
4. The TTL output signal is low level, allows us to connect with SCM directly.
5. Analog output 0~5V voltage.
6. Quick response and recovery.