BC547 is an NPN Transistor. It has a gain value of 110 and a collector current of 100mA.
![](https://kazrotech.com/wp-content/uploads/2022/10/BC547NPNTransistorA-150x150.jpg)
![](https://kazrotech.com/wp-content/uploads/2022/10/BC547NPNTransistorB-150x150.jpg)
BC547 NPN DIP Transistor – 1 Piece
₹4.50 Original price was: ₹4.50.₹3.00Current price is: ₹3.00.
Price Summary
- ₹4.50
- ₹3.00
- 33%
- ₹3.00
- Overall you save ₹1.50 (33%) on this product
1. BC547 is a bipolar junction transistor (BJT).
2. It is kind of an NPN transistor.
3. It has three terminals: Emitter, Collector and Base.
4. The maximum current gain of BC547 is 800A.
Weight | 0.01 kg |
---|---|
Dimensions | 0.45 × 0.35 × 1.9 cm |
Be the first to review “BC547 NPN DIP Transistor – 1 Piece” Cancel reply
Related Products
Male To Male Jumper Wires (20cm) – 40 Pieces
1. 40P color DuPont line
2. Length: 200mm
3. Weight: 30 gm
4. Compatible with 2.54mm spacing pin headers
5. 40pcs chromatic male to male color jump wire
6. High quality and in good working condition
7. Durable and reusable
8. Easy to install and use
Female To Female Jumper Wires (20cm) – 40 Pieces
1. 40P color DuPont line
2. Length: 200mm
3. Weight: 30 gm
4. Compatible with 2.54mm spacing pin headers
5. 40pcs chromatic female to female color jump wire
6. High quality and in good working condition
7. Durable and reusable
8. Easy to install and use
Aligator Clip Jumper Wire
1. Colour: Red, Green, Yellow, White, and Black, etc.
2. Cable length: 45 cm.
3. Net weight: 82 gm.
4. They are very useful for connecting components to wires.
5. It is insulation covered clips connected to the wire from both ends.
8 Channel Relay Board 5V
1. Channel: 8 channel
2. Relay Operating Voltage: 5V
3. One normally closed contact and one normally open contact
4. Triode drive, increasing relay coil
5. High impedance controller pin
6. Pull-down circuit for the avoidance of malfunction
7. Power supply indicator and Control indicator lamp
8. Power supply and relay instructions, lit, the disconnect is off;
1K Ohm 1/8W Through Hole Resistor (Pack of 5)
1. Resistance: 1K Ohm
2. Tolerance: ±5%
3. Max. Working Voltage: 250V
4. Temperature Coefficient of Resistance: 50PPM/°C
100 Ohm 1/8W Through Hole Resistor (Pack of 5)
1. Resistance: 100 Ohm
2. Tolerance: ±5%
3. Max. Working Voltage: 250V
4. Temperature Coefficient of Resistance: 50PPM/°C
Keypad 4*4 Membrane
1. Ultra-thin design & adhesive backing provides easy integration to any project
2. Excellent price-performance ratio
3. Easy communication with any microcontroller
4. 5 pins 2.54mm pitch connector, 4×4 type – 16 keys.
5. Sticker can peel off for adhesive mounting.
6. Operating Voltage (V): 12 DC
1 Channel Relay Board 5V with Optocoupler
1. Channel – 1
2. Trigger Voltage (VDC) – 5
3. Switching Voltage (VAC) – 250@10A
4. Switching Voltage (VDC) – 30@10A
TTP223 Touch Sensor Module
1. Power supply voltage(VCC): 2.0, 3, 5.5 V.
2. Output high VOH: 0.8VCC V
3. Output low VOL: 0.3VCC V
4. Response time (touch mode) : 60 mS
5. Response time (low power mode) : 220 mS
6. Can replace the traditional touch of a button
7. Four M2 screws positioning holes for easy installation
NE555 Timer Switch Adjustable Relay Board
1. Module based on the NE555 chip.
2. Input voltage: DC 12V
3. Adjustable time: 0-10 s
4. AC Control voltage: 250V/max. 10A
5. Max. load: 2200W
650NM Laser Diode
1. Output Power: 5mW
2. Working Voltage: 5V DC
3. Working temperature: -10 ℃~+40 ℃
4. Housing material: Copper
5. Working life: more than 2000 hours
6. Spot mode: Dot Facula (continuous output)
7. Laser wavelength: 650nm red-colored.
8. Operating current: <40mA
9. Power lead length: 120mm.
Keypad 4*3 Membrane
1. Ultra-thin design & adhesive backing provides easy integration to any project
2. Excellent price-performance ratio
3. Easy communication with any microcontroller
4. 5 pins 2.54mm pitch connector, 4×3 type – 12 keys.
5. Sticker can peel off for adhesive mounting.
6. Operating Voltage (V): 12 DC
There are no reviews yet.