It is a 330 Ohm 0.25W Metal Film Resistor. This resistor is for through-hole applications.
330 Ohm 1/8W Through Hole Resistor (Pack of 5)
₹12.00 Original price was: ₹12.00.₹10.00Current price is: ₹10.00.
Price Summary
- ₹12.00
- ₹10.00
- 17%
- ₹10.00
- Overall you save ₹2.00 (17%) on this product
1. Resistance: 330 Ohm
2. Tolerance: ±5%
3. Max. Working Voltage: 250V
4. Temperature Coefficient of Resistance: 50PPM/°C
Weight | 0.01 kg |
---|---|
Dimensions | 0.45 × 0.35 × 1.9 cm |
Be the first to review “330 Ohm 1/8W Through Hole Resistor (Pack of 5)” Cancel reply
Related Products
Female To Female Jumper Wires (20cm) – 40 Pieces
1. 40P color DuPont line
2. Length: 200mm
3. Weight: 30 gm
4. Compatible with 2.54mm spacing pin headers
5. 40pcs chromatic female to female color jump wire
6. High quality and in good working condition
7. Durable and reusable
8. Easy to install and use
Aligator Clip Jumper Wire
1. Colour: Red, Green, Yellow, White, and Black, etc.
2. Cable length: 45 cm.
3. Net weight: 82 gm.
4. They are very useful for connecting components to wires.
5. It is insulation covered clips connected to the wire from both ends.
2 Channel Relay Board 5V
1. No. of Channel: 2
2. Trigger Voltage: 5VDC
3. Triode drive, increasing relay coil
4. High impedance controller pin
5. Pull-down circuit for the avoidance of malfunction
6. Power supply indicator and Control indicator lamp
7. Power supply and relay instructions, lit, the disconnect is off;
8. The input signal, signal, common Terminal and start conducting;
NE555 Timer Switch Adjustable Relay Board
1. Module based on the NE555 chip.
2. Input voltage: DC 12V
3. Adjustable time: 0-10 s
4. AC Control voltage: 250V/max. 10A
5. Max. load: 2200W
BC547 NPN DIP Transistor – 1 Piece
1. BC547 is a bipolar junction transistor (BJT).
2. It is kind of an NPN transistor.
3. It has three terminals: Emitter, Collector and Base.
4. The maximum current gain of BC547 is 800A.
10K Ohm 1/8W Through Hole Resistor (Pack of 5)
1. Resistance: 10K Ohm
2. Tolerance: ±5%
3. Max. Working Voltage: 250V
4. Temperature Coefficient of Resistance: 50PPM/°C
Motor Driver – L293D
1. The driver two holes of 3 mm dia.
2. Male burg-stick connectors for supply, ground and input connection.
3. Screw terminal connectors for easy motor connection.
4. High noise immunity inputs.
5. Operating Voltage(VDC): 4.5 to 12
6. Peak Current (A): 600 mA
7. No. of Channels: 1
4 Channel Relay Board 5V
1. No. of Channel: 4
2. Trigger Voltage: 5VDC
3. Triode drive, increasing relay coil
4. High impedance controller pin
5. Pull-down circuit for the avoidance of malfunction
6. Power supply indicator and Control indicator lamp
7. Power supply and relay instructions, lit, the disconnect is off;
8. The input signal, signal, common Terminal and start conducting;
Keypad 4*3 Membrane
1. Ultra-thin design & adhesive backing provides easy integration to any project
2. Excellent price-performance ratio
3. Easy communication with any microcontroller
4. 5 pins 2.54mm pitch connector, 4×3 type – 12 keys.
5. Sticker can peel off for adhesive mounting.
6. Operating Voltage (V): 12 DC
Motor Driver – L298N
1. Current Sense for each motor.
2. Heatsink for better performance.
3. Power-On LED indicator.
4. Double H bridge Drive Chip: L298N.
5. Operating Voltage(VDC): 5~35
6. Peak Current (A): 2
7. Continuous Current (A): 0-36mA
8. No. of Channels: 2
9. Over-Current Protection (A): Yes
10. Thermal Protection: Yes
Male To Female Jumper Wires (20cm) – 40 Pieces
1. 40P color DuPont line
2. Length: 200mm
3. Weight: 30 gm
4. Compatible with 2.54mm spacing pin headers
5. 40pcs chromatic male to female color jump wire
6. High quality and in good working condition
7. Durable and reusable
8. Easy to install and use
TTP223 Touch Sensor Module
1. Power supply voltage(VCC): 2.0, 3, 5.5 V.
2. Output high VOH: 0.8VCC V
3. Output low VOL: 0.3VCC V
4. Response time (touch mode) : 60 mS
5. Response time (low power mode) : 220 mS
6. Can replace the traditional touch of a button
7. Four M2 screws positioning holes for easy installation
There are no reviews yet.