650nm 6mm 5V DC 5mW Mini Laser Dot Diode Module which is made of copper plastic. It is suitable for 3V 5mW standard, with 6mm outside diameter, can be used to connect diode tubes for multiple uses.
650NM Laser Diode
₹35.00 Original price was: ₹35.00.₹32.00Current price is: ₹32.00.
Price Summary
- ₹35.00
- ₹32.00
- 9%
- ₹32.00
- Overall you save ₹3.00 (9%) on this product
1. Output Power: 5mW
2. Working Voltage: 5V DC
3. Working temperature: -10 ℃~+40 ℃
4. Housing material: Copper
5. Working life: more than 2000 hours
6. Spot mode: Dot Facula (continuous output)
7. Laser wavelength: 650nm red-colored.
8. Operating current: <40mA
9. Power lead length: 120mm.
Weight | 0.06 kg |
---|---|
Dimensions | 3 × 3 × 2 cm |
Be the first to review “650NM Laser Diode” Cancel reply
Related Products
Male To Female Jumper Wires (20cm) – 40 Pieces
1. 40P color DuPont line
2. Length: 200mm
3. Weight: 30 gm
4. Compatible with 2.54mm spacing pin headers
5. 40pcs chromatic male to female color jump wire
6. High quality and in good working condition
7. Durable and reusable
8. Easy to install and use
8 Channel Relay Board 5V
1. Channel: 8 channel
2. Relay Operating Voltage: 5V
3. One normally closed contact and one normally open contact
4. Triode drive, increasing relay coil
5. High impedance controller pin
6. Pull-down circuit for the avoidance of malfunction
7. Power supply indicator and Control indicator lamp
8. Power supply and relay instructions, lit, the disconnect is off;
Aligator Clip Jumper Wire
1. Colour: Red, Green, Yellow, White, and Black, etc.
2. Cable length: 45 cm.
3. Net weight: 82 gm.
4. They are very useful for connecting components to wires.
5. It is insulation covered clips connected to the wire from both ends.
9V Battery Connector With DC Pin
1. Excellent material
2. It is an environmental 9V battery buckle
3. The Cable Length: 12cm Approx.
4. Convenient for connecting a battery to your application.
5. Save power and protect the environment
6. Good electrical conductivity and comfortable sense of touch
Male To Male Jumper Wires (20cm) – 40 Pieces
1. 40P color DuPont line
2. Length: 200mm
3. Weight: 30 gm
4. Compatible with 2.54mm spacing pin headers
5. 40pcs chromatic male to male color jump wire
6. High quality and in good working condition
7. Durable and reusable
8. Easy to install and use
4 Channel Relay Board 5V
1. No. of Channel: 4
2. Trigger Voltage: 5VDC
3. Triode drive, increasing relay coil
4. High impedance controller pin
5. Pull-down circuit for the avoidance of malfunction
6. Power supply indicator and Control indicator lamp
7. Power supply and relay instructions, lit, the disconnect is off;
8. The input signal, signal, common Terminal and start conducting;
Keypad 4*3 Membrane
1. Ultra-thin design & adhesive backing provides easy integration to any project
2. Excellent price-performance ratio
3. Easy communication with any microcontroller
4. 5 pins 2.54mm pitch connector, 4×3 type – 12 keys.
5. Sticker can peel off for adhesive mounting.
6. Operating Voltage (V): 12 DC
2 Channel Relay Board 5V
1. No. of Channel: 2
2. Trigger Voltage: 5VDC
3. Triode drive, increasing relay coil
4. High impedance controller pin
5. Pull-down circuit for the avoidance of malfunction
6. Power supply indicator and Control indicator lamp
7. Power supply and relay instructions, lit, the disconnect is off;
8. The input signal, signal, common Terminal and start conducting;
Motor Driver – L293D
1. The driver two holes of 3 mm dia.
2. Male burg-stick connectors for supply, ground and input connection.
3. Screw terminal connectors for easy motor connection.
4. High noise immunity inputs.
5. Operating Voltage(VDC): 4.5 to 12
6. Peak Current (A): 600 mA
7. No. of Channels: 1
TTP223 Touch Sensor Module
1. Power supply voltage(VCC): 2.0, 3, 5.5 V.
2. Output high VOH: 0.8VCC V
3. Output low VOL: 0.3VCC V
4. Response time (touch mode) : 60 mS
5. Response time (low power mode) : 220 mS
6. Can replace the traditional touch of a button
7. Four M2 screws positioning holes for easy installation
Female To Female Jumper Wires (20cm) – 40 Pieces
1. 40P color DuPont line
2. Length: 200mm
3. Weight: 30 gm
4. Compatible with 2.54mm spacing pin headers
5. 40pcs chromatic female to female color jump wire
6. High quality and in good working condition
7. Durable and reusable
8. Easy to install and use
Motor Driver – L298N
1. Current Sense for each motor.
2. Heatsink for better performance.
3. Power-On LED indicator.
4. Double H bridge Drive Chip: L298N.
5. Operating Voltage(VDC): 5~35
6. Peak Current (A): 2
7. Continuous Current (A): 0-36mA
8. No. of Channels: 2
9. Over-Current Protection (A): Yes
10. Thermal Protection: Yes
There are no reviews yet.