CNC Shield For A4988
1. Latest Arduino CNC Shield Version 3.10
2. GRBL 0.9 compatible. (Open source firmware that runs on an Arduino UNO that turns G-code commands into stepper signals)
3. Coolant enable
4. Jumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do up to 1/32 micro-stepping )
5. Compact design.
6. 4-Axis support (X, Y, Z, A-Can duplicate X, Y, Z or do a full 4th axis with custom firmware using pins D12 and D13)
7. 2 x End stops for each axis (6 in total)
L298P Motor Driver Shield
1. L298P based Arduino motor driver shield
2. Onboard Buzzer (D4).
3. Onboard Bluetooth interface, you can directly plug, no wiring required.
4. Six Analog interface.
5. Forward, Backward steering indicators
L9110 DC Stepper Motor Driver Board HBridge
- Power supply voltage: DC2.5-12V
- Each channel has 800mA continuous current output
- Low saturation pressure drop
- TTL/CMOS output level compatible can be connected directly to the CPU
- Control and drive integrated into IC
- Have pin high-pressure protection function
Motor Driver – L298N
1. Current Sense for each motor.
2. Heatsink for better performance.
3. Power-On LED indicator.
4. Double H bridge Drive Chip: L298N.
5. Operating Voltage(VDC): 5~35
6. Peak Current (A): 2
7. Continuous Current (A): 0-36mA
8. No. of Channels: 2
9. Over-Current Protection (A): Yes
10. Thermal Protection: Yes
Motor/Stepper/Servo Shield v2 For Arduino
1. This serrvo motor shield compatible with arduino is used for vehicles & Remote Control Toys.
2. It’s an I2C-controlled PWM driver with a built-in clock.
3. The 12 bit servo motor also features protection against reverse polarity on the terminal block input.